Staining a Deck

Midwestpro · Posted: Sun Jan 27, 2008 9:55 pm Post subject: Staining a Deck

Staining a deck without washing it first, is that possible?

The answer to this question is NO, not if you want the sealer to penetrate properly and last. The number one reason a sealer fails is because the wood was not prepared properly. Even a very expensive sealer is not going to do its job unless the wood has been prepped correctly. Special chemicals need to be used to remove dead fibers, dirt, mildew and other pollutants and it all has to be cleaned using low water pressure so the wood isn’t damaged.

In some cases a deck sealer stripper is used to remove an old failing sealer, it is important to remove all traces of old sealers so the new sealer can adhere to the wood. Contractors using the proper stripping technique will depend heavily on their chemicals to do the work so the right amount of low pressure can be used.

After the cleaning or stripping process a neutralizing step is then needed. The reason for this is because the cleaner or stripper used is considered a caustic and will leave the wood with a high PH level. Deck sealer does not adhere well or properly in this situation. A neutralizer is sprayed on the wood to lower the PH and leave the wood more acidic so the sealer will protect and last a couple years like expected.

Deck restoration and maintenance is a wonderful service when done right, it saves you money by protecting your added living space.